High - Precision Water Level Meter with Error ≤±0.5mm

With comprehensive technical parameters and a flexible design, this water level gauge can widely meet various water level monitoring needs: its water quality adaptation range covers 10μω～1000μω, capable of handling monitoring scenarios from clean water to slightly polluted water; it offers four gear options for depth measurement (0～30m, 0～50m, 0～100m, 0～150m), combined with a reading accuracy of ≤±0.5mm and an output response speed of ≤1ms. Whether for underground deep wells, reservoirs or industrial water storage tanks, it can provide accurate and real-time water level feedback, offering reliable data support for water level management in different fields.

Features:

Water level meter is used new integrated circuit board design It has the following features:

1. Adopt anti-polarization excitation circuit and corrosion resistance electrode can effectively prevent the electrode oxidation rust and keep long-term constant sensitivity.
2. Quick response circuit design with high speed and high sensitivity.
3. Low power consumption: battery power can work two years.
4. The cable with the scale measuring tape measure the water level directly .

Product technology:

Operation:

1. Real time measure: loosen stop screw of the reel to allow rotation freely.
2. Turn on power button (the power indicator light). Put water level probe into the tube, holding steel ruler cable to let the probe down slowly. When the probe sensors contact water surface, the receiving system sounder will emit continuous beep. The ruler cable depth reading is the water level depth.

If in noise environment, can not hear beep. So change use peak indicating method. Turn on switch to voltage level. And do as beep method procedure.

Must be noted: : When the probe contacts water surface, the beeper will sound, or voltmeter indicated immediately. Should low down slowly to find exact point.

Attention:

1. Due to battery capacity, should turn off immediately after measurement. When replace the battery, should open the battery cover to replace battery.
2. Must be clean and wipe probe and ruler after measurement.And wind the ruler on the reel and place in bin.
3. To avoid damage, probe should seal work.
4. And problems, please feel free contact us.
5. Ruler cable should avoid bent, special on top end.
6. Light take and place, to avoid severe shock.
7. Should keep in -10℃～+40℃, humidity is <80% and non-corrosiveness environment.